Flooring’s Cleaning and Maintenance

Protection

1.Protect the floor covering installation against dirt and other trades.
2.The finished floor should be protected from exposure of direct sunlight to avoid fading.
3.To avoid possible permanent indentation or damage, proper non-marking floor protection devices must be used under furniture and appliances. Exercise care when removing and replacing furniture or appliances.
4.Temperature and humidity after the flooring covering installation must be maintained, ensure that room temperature is kept between 18-26 degree and relative humidity between 45-65%.

Cleaning and Maintenance

For routine cleaning:

Thoroughly sweep or vacuum floor before washing.Add I once (4 ML/L)of a neutral floor cleaner to 1 gallon of warn water. Damp mop the floor using a clean sponge or mop best results, continue to rinse the mop or sponge throughout the cleaning process.

For extra dirty floors:

Add 2 ounces(8ML/L)of a neutral floor cleaner to 1 gallon of warm water. Damp mop the floor using a clean sponge or mop for best results, continue to rinse the mop or sponge throughout the cleaning process.

 For heavily solid areas:

Add 8 ounces(50ML/L)of neutral floor cleaner to gallon of warm water and allow it to saturate for 3-4 minutes. Use a white scrub brush or nylon pad may be used to loosen dirt.

For best result, continue to rinse the brush or pad throughout the cleaning process.

Coatings:

If an extra is desired a low gloss satin finish is recommended, applied according to the manufactures recommended procedures. Once a coating is applied, a regular maintenance program will be required to strip the floor and re-coat the flooring according the manufactures recommendations.